Apple Inc. Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Apple Inc.

AAPL 262.22

-1.9%

Jan 6 3:59 PM EST

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: Rishi Gupta who wrote (18243)	9/23/1998 12:10:00 AM
From: Brian Collins	Read Replies (1) of 213180

R. <<How to make or where can you buy a cross cable?>> Pick 4 of the 8 conductors in the ethernet cable. I used Blue, White/Blue, Green & White/Green. If you place the RJ-45 connector on the palm of your hand, upside down (so the release clasp is setting on your palm) and pointing away from you (so that the open end into which you would insert the cable is pointing toward you and the copper conductors are pointing away from you), then the pinouts from left to right would be numbered 1-8 and color coded as follows: 1 White/Green 2 Green 3 White/Blue 4 empty 5 empty 6 Blue 7 empty 8 empty Install the cable and crimp. On the other end use this sequence, install cable and crimp: 1 White/Blue 2 Blue 3 White/Green 4 empty 5 empty 6 Green 7 empty 8 empty <<Where's a Ethernet bridge control software available?>> It's a single control panel called "Laserwriter Bridge," should be installed on the Centris with ethernet and can be had at: ftp://ftphqx.info.apple.com/Apple.Support.Area/Apple.Software.Updates/US/Macintosh/Networking-Communications/Other_N-C/LT_and_LW_Bridge_2.1.sea.hqx good luck, brian

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next