Computer Learning Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Pastimes : Computer Learning

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: RJL who wrote (5672)	9/12/1999 1:17:00 PM
From: TimbaBear	Read Replies (3) of 110653

Sorry to intrude, but I've got a dumb question or two....I have an old HP4P Flatbed scanner that I tried to use on my new system and had so much fun, I've decided not to proceed....however, the process has left behind a few dingleberries that I would like to clean up. First, the installation process did not complete, and therefore I could not use "ADD/REMOVE PROGRAMS" to remove the offending partially installed software. Second, I have removed everything that it installed that it will let me remove except for the C:\PAPERPORT file it created and three files within it that it says I cannot remove because they are shared with something else(but it doesn't tell me what). Third, I could live with those files being there, but now every time I boot, I get a message that demands my attention (the boot stops until I hit the "enter" key) that says that the Paperport software was not properly installed (ain't that just so special?). I think the instructions are probably in the Config.sys or Autoexec.bat files but I forget how to access them and edit them and that is the help I'm hoping you can provide. The system is a NEC yadda yadda plain vanilla with Win95

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next