Micron Only Forum Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Micron Only Forum

MU 227.73

-4.5%

12:11 PM EST

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: AurumRabosa who wrote (48656)	9/24/1999 3:20:00 PM
From: Fabeyes	Read Replies (1) of 53903

This is true, unless they are vertical furnaces, which more and more of the world is converting to. You have to be able to do the smaller geometry's. A concern might be the loss of power causing all of the furnaces, etchers and steppers to be replace, or recalibrated -- this could take time. In addition, the compromising of the podded reticules may be of some concern. The bottom line may be not what was damaged but what is left to access the damage. If they lost KLAs or defect monitor type machine, they would have nothing to say this may be good or bad. Getting a standard device could be difficult.

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next