SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Pastimes : Dream Machine ( Build your own PC )
 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext  
To: peter michaelson who wrote (8979)10/3/1999 1:04:00 PM
From: Dan Spangenberg  Read Replies (1) of 14778
 
If you are using the Cisco 675, why are you using Sygate? The 675 does NAT translation seamlessly, without any software required on any workstation. All you need to do is to enable NAT on the Cisco.
The commands are:

set nat enabled
set interface eth0 address 10.0.0.1
set interface eth0 netmask 255.255.255.0

then write and reboot.
Set the gateway field in each PC to 10.0.0.1 and turn off sygate. Each of them will have net access without using sygate. If you are using a different IP numbering scheme, then adjust the above numbers accordingly.

Give it a try, works great here. I like this because you are not dependent on 1 machine running sygate. The if you only have one PC running, it can have access without the other one.
My problem is that Is I just can't see each other in network neighborhood, which is a different problem. Working on it right now.

Good Luck
Dan
Report TOU ViolationShare This Post
 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext  

HomeMailHotSubjectMarksPeopleMarksKeepersSettings
Terms Of UseContact UsCopyright/IP PolicyPrivacy PolicyAbout UsFAQAdvertise on SI
© 2026 Knight Sac Media.  Data provided by Twelve Data, Alpha Vantage, and CityFALCON News