Thanks, Mowa, and Thomas,
for paying attention.
The problem with installing Corel Linusx is:
My system stalls after Loading Linux - Starting Linux.
I then have to reset the machine to free it.
I tried booting from CD and booting from floppy - both same result.
My system has UW SCSI.
Normally it boots from SCSI drive C:.
But I switched the BIOS Setup to booting from IDE.
The IDE hard disk is DOS formatted but completely empty.
I tried booting from the CD-ROM as well as from a floppy: same result.
I skipped norton Antivirus with the appropriate hotkeys.
My configuration is:
Pentium II 350 MHz
Asus P2B-F board,
64 MB SDRam,
Floppy drive (drive A:)
Adaptec AHA2940 UW SCSI adapter,
IOMEGA ZIP 100 SCSI (drive G:),
Plextor Ultraplex SCSI CD-ROM, (drive H:)
Plextor Plexwriter SCSI CD-writer (drive I:),
IBM DGHS 9.1 GB Ultra Wide SCSI hard disk (drive C: and E:),
IBM DJNA 371350 13.5 GB IDE (ATA) hard disk (drive D: and F:)
Asus AGP V3400 TNT RIVA graphic card,
Terratec EWS64XL Soundcard,
Etech Bullet V90 modem,
Eizo F563-T monitor 1024x728 at 100Hz refresh rate,
HP Laserjet 6MP with 2x16MB extra memory, HP Postscript driver from 1997.
Windows 98 Dutch, DirectX6.0 Dutch.
I Would be very happy if you can suggest a solution
Eveline |
