Dream Machine ( Build your own PC ) Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Pastimes : Dream Machine ( Build your own PC )

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: mappingworld who wrote (10324)	2/6/2000 11:59:00 AM
From: Howard R. Hansen	Read Replies (1) of 14778

I should add that when I just look in my explorer I don't see the partition added. Need I format it? Isn't it already formatted? Sigh? Explorer, Windows, will not see the LINUX partition. Say you have a 8 gigabyte hard disk and you create two 4 gigabytye partitions, one for LINUX and one for Windows. Now when you run Windows, Windows will think and act like you only have a 4 gigabyte hard disk. However, LINUX can access your Windows partition. I know LINUX can read and write to 16 bit FAT files in a Window's partition but I do not know if the capability to read and write to 32 bit FAT files in a Window's partitions has been added to LINUX yet. Do not use DOS/Windows to format your LINUX partition. LINUX uses a different type of file system and will do its own formatting. All seemed to go well until it asked me where, ie drive & partition, to put the beast. It said I needed to define the root partition. It has been about 3 years since I did this and I have forgotten a lot of the details. But it seems like the process went as follows. One you first tell Linux what partition to use. When you ran partition magic, PM, it should have ask what type of partitions you were creating. At this point you should have told PM, one was a Windows/DOS type partition and the other was a LINUX type partition. Pick the LINUX partition. Then eventually you will need to tell LINUX how to divide the LINUX partition. Yes this may sounds confusing but you will end up with a LINUX partition divided into at least three subsections. One for ROOT files, one for SWAP files, and one for USER files. There should be some documentation that came with LINUX that provides recommendations about what size in bytes each of these subsections should be.

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next