SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Politics : Formerly About Advanced Micro Devices

 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext  
To: Mani1 who wrote (98052)3/12/2000 2:26:00 PM
From: Charles R  Read Replies (1) of 1572503
 
Mani,

<According to here---http://developer.intel.com/design/pentiumiii/datashts/24445206.pdf ---
1 GHz has max junction temp is 60 degrees C !!!! This is amazing! A nice fella pointed this out to me by emailing me this post

aceshardware.com Very nice post and 100% accurate.

The fact of the matter is that 1GHz Coppermine has a much more aggressive thermal design requirement than the 1 GHz Athlon, not to mention much more expensive.>

Thanks for the informative post. 60 degrees junction temp! Will be interesting to see what Paul has got to say about this.

<The fact of the matter is that 1GHz Coppermine has a much more aggressive thermal design requirement than the 1 GHz Athlon, not to mention much more expensive.>

Can you quantify the "more expensive" part? Any estimates on the relative costs of cooling 1G Athlons and 1G PIIIs?

<1 GHz Coppermine needs the total thermal resistance from the die to air in the case, of less than 0.8 W/C! That is very low. It is only doable with high speed fans and finely bonded (not extruded which is much cheaper) aluminum sink and a thick copper spreader.>

This is a two sided story: On one side it shows Intel's desperation to give a perception that it can compete on Mhz basis, the other side is that Intel has the resources to pull all stops to do this kind of stuff.

Chuck
Report TOU ViolationShare This Post
 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext