Cyrix 1 Where anything goes Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Cyrix 1 Where anything goes

CYRX 8.395

+0.8%

Nov 7 9:30 AM EST

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: Jon Layish who wrote (466)	5/19/1997 6:46:00 PM
From: Mark A. Forte	of 640

I may have mentioned on reset P166 is displayed. This just adds to the wierdness. I have checked jumper settings by the book. I'll have to see if the book matches the silkscreen. Do you know of a combination glue heatsink compound? I was setting a motherboard up yesterday and the spring clip on the heatsink had too much tension. I had a hard job getting it connected to the socket. You guessed it the plastic tab on the socket broke off. I have it jury rigged but would like to glue the heatsink to the CPU. Any suggestions would be greatly appreciated because this is definately in the category engineers call ah $hit.

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next