Intel Corporation (INTC) Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Intel Corporation (INTC)

INTC 48.32

-0.8%

Jan 15 3:59 PM EST

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: Dan3 who wrote (158226)	2/9/2002 6:13:09 AM
From: Tenchusatsu	Read Replies (1) of 186894

Dan, <The 3.3V AGP standard pre-dated the existence of 1.5V cards, and so many of the 3.3V cards don't comply with the notch configuration that supports 1.5V cards.> You are so full of it. The cards that run into the problem have the "universal" connector, i.e. keyed for both 1.5V and 3.3V. The 3.3V cards made before the release of the AGP 2.0 would not have the universal connector, because the spec WASN'T RELEASED YET. From your link: bbs.pcstats.com Boards that run at 3.3V should not be advertised at 1.5V-compliant. The manual for Intel's P4 motherboards say that they only support 1.5V AGP cards. I should know; I have one. If a 1.5V AGP card doesn't actually run at 1.5V, then it's NOT INTEL'S FAULT. And if some DIY'er plugged in a 3.3V card without reading the f-----' manual, it's NOT INTEL'S FAULT. Your constant rants are similar to blaming AMD just because someone built a system without an "AMD-approved" power supply, or installed memory that didn't fall within AMD's compatibility list. Why don't you make a big fuss over that? Tenchusatsu

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next