SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Technology Stocks : Rambus (RMBS) - Eagle or Penguin
RMBS 93.87-1.5%1:36 PM EST

 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext  
To: cordob who wrote (81663)3/22/2002 2:53:50 AM
From: Ian Anderson  Read Replies (2) of 93625
 
Rambus, and most of it's imitators, use an AC termination scheme. That means they have a resistor and a capacitor in series to ground. b.t.w they did not invent this, it's a well documented technique from at least 1985, probably much earlier.

This means that power is dissipated in the resistors only when something is changing on the bus, and not when it is static.

I thought Rambus always used a 28 Ohm impedance bus, which was one of the factors which made motherboard design a challenge to start with.

So the answer is that on a heavily loaded bus the dissipation is proportional to the clock speed, and PC1066 will therefore dissipate more. However since it's voltage swings are lower, the problem both with dissipation and RF radiation is less bad than trying to make DDR go faster.
Report TOU ViolationShare This Post
 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext