Bush-The Mastermind behind 9/11? Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Politics : Bush-The Mastermind behind 9/11?

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: David Howe who wrote (16047)	9/20/2006 11:34:49 AM
From: Orcastraiter	Read Replies (2) of 20039

I propose that a simple test be conducted. First we all agree that the building fell in 9-10 seconds. That's free fall time. Therefore the top floors and the roof arrived at the ground in about the same time as they would if they were hoisted by a crane or a helicopter and let go in mid air. For the test we'll need to construct three floor sections on pans and trusses. Say 12x12 with three truss sections supporting them. Then pour the specified concrete deck and reinforcement...if any...and let it cure hard, say 60 days min. Attach cables to the corners of the three test floors, so that when hoisted the floors hang a floor a part. Then sling the top four corners with four more cables to a central hook. Make sure the top four cables are at least 100 feet long. Hoist the three floor assembly aloft with a helicopter to 1320 feet above the ground and release the load to some flat ground below. Be sure to let the 100' hoist cable go with the load to act as a tail and keep the floors horizontal while falling. Then after it hits the ground, check to see if the steel pans vaporize. Check the concrete size to see if all turns to 30 micron dust. What will a test like that tell us?

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next