Apple Inc. Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Apple Inc.

AAPL 278.28

+0.1%

Dec 12 9:30 AM EST

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

Recommended by:

Doren

To: Doren who wrote (166484)	2/25/2014 11:39:48 PM
From: HerbVic	1 Recommendation Read Replies (1) of 213176

Hmmm… While reading your post with your description of the technical hurtles to be overcome with LM injection molding process, a little voice in the back of my mind kept saying, "Centrifuge. Large heat sink capacity. Dual walled chamber. Twin (or quad) mold with vacuum injection. The two molds counterbalance each other on opposite sides of the axis of rotation. Processing steps after start of spin, 1> Pull vacuum. 2> Flow molten metal. 3> Stop spin & apply heat sink. 4> Open mold and eject part." Yep! They've got a difficult one to overcome there. Then I noticed that at the end you mentioned that they already tried that.

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next