Micron Only Forum Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Micron Only Forum

MU 394.69

+3.1%

Feb 6 9:30 AM EST

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: ratan lal who wrote (32638)	4/29/1998 3:40:00 PM
From: DavidG	Read Replies (1) of 53903

Ratan, It sounds like you are not just fooling around with the software but possibly getting your fingers inside the case.<g> If so then there are many more possibilities to where your problem exists.<vbg> Check the polarity of cables. on hard drive and motherboard. Red stripe points to power connector and is #1 pin. Then check Floppy cable. Also use defaults in bios. Can't think of other typical mistakes but just try and back track your changes. Still find it difficult to believe it is a hardware problem based on what you told me.:-) DavidG

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next