Dream Machine ( Build your own PC ) Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Pastimes : Dream Machine ( Build your own PC )

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: Zeuspaul who wrote (1439)	6/20/1998 7:51:00 PM
From: Howard R. Hansen	Read Replies (1) of 14778

>> Some I can only figure out by comparing to the way Compaq fit the cables together. << The side of the flat ribbon cable with the red stripe always gets connected to the Pin 1 side of the mating connector. Sometimes it is hard to find the Pin 1 side of the mating connector. You might have to remove a hard disk or a controller from your cabinet to read the labels. But I have yet to find a drive or controller that didn't have Pin 1 identified.

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next