Speedfam [SFAM] Lovers Unite ! Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Speedfam [SFAM] Lovers Unite !

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: hydrozonie who wrote (3101)	7/9/1998 12:24:00 AM
From: Donald B. Fuller	Read Replies (2) of 3736

>>When I owned its stock, SFAM appeared to be putting most of its research and development efforts into 300 mm tools and tools able to process copper. It seems they were putting less effort in developing 0.18 nm capability. So, first of all, does anyone know where SFAM currently is in these three directions?>> I'm not a semi engineer but believe there is no special difference in the CMP requirement between .25, .18, .13, etc.. They are just planarizing the wafers, not etching them. If I'm speaking out of school and one of you real engineering types knows better, by all means correct me. Don

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next