Dream Machine ( Build your own PC ) Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Pastimes : Dream Machine ( Build your own PC )

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: Zeuspaul who wrote (6667)	3/8/1999 12:03:00 AM
From: Clarence Dodge	Read Replies (1) of 14778

ZP CNC..stands for Computer Numeric Control I see...the router attaches to some rigging which is in turn controled by CNC software. Do you have to install the jumper cable?? or is it an option? Which series Dataport did you opt for? I got the VII in both ide and scsi. I don't know if the hdd jumper cabling comes with other Dataports. It is optional use on the VII,as far as I can tell. All it does is tell Dataport how the drive is jumpered so an LED on the cartridge can lite up as either master or slave. They're just replacement jumpers attached to wires that go back to the Dataport board on the frame. Is it w98 that can't see drives larger than 8.4 g as one volume? Like i said the 17.2 gig maxtor showed up in NT Disk Administrator as 16.something gig. I haven't gone into w98 to see how its seen from there. Simple enough to do...i'll take a look.. Good to have you back in position..I hope you and Spots are done traveling for awhile<g> Clarence

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next