Qualcomm Incorporated (QCOM) Message Board

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Qualcomm Incorporated (QCOM)

QCOM 173.62

+1.2%

11:21 AM EST

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next

To: Boplicity who wrote (25776)	4/1/1999 2:22:00 PM
From: edwin k.	Read Replies (1) of 152472

take a couple of torches (butane type) and heat the area of the drum where the flat surface of the drum lays against the flat surface underneath (the disc that the lugs are mounted into. Then, after getting good and hot, beat on the same area with a hammer all around that area. You should see in begin to loosen up. Water and rust gets between the two flat surfaces and binds them sometimes. Two torches of the butane type will get the area hotter than one torch obviously. (It is difficult to get enuff heat built up when trying to heat such a massive hunk of steel and/or cast iron) EDWIN K

Report TOU Violation

Share This Post

Public Reply Prvt Reply Mark as Last Read File

Previous 10 Next 10 Previous Next