Silicon Investor (SI) -- The First Internet Community

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Rambus (RMBS) - Eagle or Penguin -- Ignore unavailable to you. Want to Upgrade?

To: unclewest who wrote (33440)	10/31/1999 7:01:00 AM
From: unclewest	Read Replies (1) \| Respond to of 93625

i could not open that gateway page today... but i did copy the info...earlier. dated 25 oct, 1999 Introduction This is a Slot 1 system board that uses the Intel© 820 chipset. The system board incorporates such features as: Direct RAMBUS© RDRAM RIMM system memory 133 MHz front side bus Ultra ATA 66 drive support ACPI support AGP 4X support System board layout The following illustration shows the system board divided into two sections: Section 1 USB configuration jumper block SCSI LED connector / Wake-On-Ring (WOR) connector BIOS configuration jumper block PCI expansion slots Battery Wake-On-LAN (WOL) connector AGP expansion slot Audio Modem Riser (AMR) slot Section 2 Front panel connector Diskette drive cable connector Primary IDE cable connector Secondary IDE cable connector Slot 1 processor connector USB front panel connector Power supply connector System fan connector RIMM slots Processor fan connector PS/2 keyboard and mouse ports USB ports Parallel port Serial port A Serial port B BIOS configuration jumper settings Setting Jumper placement When used Normal For normal operation (1-2 position) Configure For clearing passwords (2-3 position) Recover For recovering the BIOS (no jumper) USB configuration jumper settings Setting Jumper placement When used AGP (default) Enables the USB port in the AGP bus and disables the USB port in the AMR slot. (2-3 and 5-6 position) AMR Disables the USB port in the AGP bus and enables the USB port in the AMR slot. (1-2 and 4-5 position) Specifications The following specifications are for the standard configuration; your system may contain optional equipment. All specifications are subject to change without notice or obligation. Processor Intel Pentium© II or Pentium© III with MMXTM Technology Chip Set Intel 82820 RAM capacity 168-pin Direct Rambus Interface Memory Module (RIMM). Three slots. Expandable to 1 GB. BIOS Intel/AMI BIOS. Flash BIOS for easy updates from diskette. IDE interfaces Supports up to four IDE devices using two on-board PCI IDE connectors. Automatic drive type selection for easy setup. Diskette drive A diskette controller is integrated on the system board. Support available for primary and secondary diskette drives and a tape backup unit (TBU). I/O ports One parallel and two serial ports on system board. LPT and COM configurable from system setup program. No jumper settings required. USB Universal Serial Bus (3 ports) Mouse PS/2 mouse connector Keyboard PS/2 keyboard connector Battery 2032-style AMR slot One slot for Original Equipment Manufacturer (OEM) use only. (Audio Modem Riser 1.01) AGP expansion slot One slot (AGP 2.0 1X/2X/4X) PCI expansion slots Five slots Power supply Supports 200 watts or 300 watts power supplies. ATX power connector for easy power cable changeover. System Environment Internal temperature: 0øC to +55øC Humidity: 20% to 80% Altitude: -60.96 m to 3048 m Shock: half-sine 2 ms Vibration: 10 Hz to 40 Hz : 0.015 g2 Hz (flat) 2 to 200 Hz, 0.25 g sinusoidal CPU clearance: >10.16 mm after installation, top and sides Many products for Gateway and its subsidiaries are custom engineered by our suppliers to Gateway specifications and may vary with similarly marketed products.