SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Non-Tech : Quote.com QCharts -- Ignore unavailable to you. Want to Upgrade?


To: paulr1 who wrote (5557)1/14/2000 5:12:00 PM
From: jebj  Read Replies (2) | Respond to of 17977
 
>but you will have to install Qcharts to two separate directories and run the executable from each.
~Paul

Unless you set up to run dual monitors with dual/mulit video cards. Then you can spread one screens program over more than one monitor. I can't say for sure but seems this would be the faster setup then the overhead to run two programs.

jb



To: paulr1 who wrote (5557)1/14/2000 5:19:00 PM
From: jebj  Read Replies (1) | Respond to of 17977
 
Paul, to add to the confussion about problems -

I normally run on my 128K ISDN line but once in a while connect up on my "normal" 56K line to check email or quotes.

Today, when I did so, I had 5 stocks on my quote sheet and two charts/L2 and T&S that would not come up and give latest data - quote sheets blank and one chart where it had been when closed and the other blank. Waited about 10 mins, changed servers but the problem never went away.

Closed and dialed in on my ISDN and all is well. Shut down and back to the 56K and same problem.

I can not think of any reason for this to happen but it could have something to do with why we have some having problems when others are not. How to trouble shoot it I have not a clue, however.

jb



To: paulr1 who wrote (5557)1/14/2000 7:15:00 PM
From: David Loomis  Respond to of 17977
 
Intentionaly left blank



To: paulr1 who wrote (5557)1/15/2000 6:42:00 PM
From: HairBall  Read Replies (1) | Respond to of 17977
 
paulr1: There was some heavy discussion a week or so ago on this thread about Q.C setting up a One List for notification only to QChart/QFeed users. You suggested that it would be a good interim solution, one that could be initiated in an hour or so.

Was it ever done? And if not, why not?

Regards,
LG