Silicon Investor (SI) -- The First Internet Community

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Pastimes : Dream Machine ( Build your own PC ) -- Ignore unavailable to you. Want to Upgrade?

To: Howard R. Hansen who wrote (10921)	5/21/2000 11:25:00 PM
From: Zeddie88	Read Replies (1) \| Respond to of 14778

microsoft.com Check your video card compatibility BEFORE you buy Windows 2000. Many cards including my ATI Expert 98s are NOT compatible! Sue :((

To: Howard R. Hansen who wrote (10921)	6/18/2000 9:17:00 PM
From: Howard R. Hansen	Read Replies (1) \| Respond to of 14778

Here is a very interesting message on wiring a 100 Mb home network that I saw posted in a news group that I felt was so important I am posting a copy here. Notice how easy it is to degrade a 100 MB home network to a 10 Mb home network. "You will certainly notice the difference between CAT-3 and CAT-5 cabling if you try running the home network at 100Mb full duplex. If I remember correctly, CAT-3 does not have the same number of twists per foot, which means cross talk and noise is different. At 10Mb half duplex (one signal pair only might be active) you probably don't notice it much, but at 100Mb Full Duplex (both pairs have active signals) you would start having problems. (Network switch assumed.) 100Mb in a home seems a little over kill, until you start considering all the home automation that you can install doing it, including voice phone over IP, video conferencing with relatives (via DSL or cable modem to outside world), and network back ups of the installed machines. When I installed the CAT-5 in my home, I certified the cabling with a Fluke DSP4000, which tests for signal-to-noise, cross talk, impedance, etc. An extra half inch to inch of untwisted cable is almost enough to fail the CAT-5 certification. We tested a RJ-45 coupler that was NOT CAT-5 certified, it failed horribly, lots of cross talk, signal to noise did not exist! The coupler was only about 1.5 inches long (total). When I took it apart the pairs were not twisted together, just all running parallel in side the coupler. The coupler would probably work fine for CAT-3, but when I tried it on CAT-5, the NIC's all fell back to 10Mb half duplex! I used "expensive" good CAT-5 cable bought from a networking supply store and the Belden cable bought from Home Depot. When certifying, you could not see any difference in the two. But we could certainly see problems when I or my daughter got sloppy and untwisted too much cable." -- Dennis Heidner