SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Strategies & Market Trends : Technology Stocks & Market Talk With Don Wolanchuk -- Ignore unavailable to you. Want to Upgrade?


To: Bull RidaH who wrote (5426)11/14/2002 5:07:03 AM
From: robert b furman  Read Replies (1) | Respond to of 206881
 
Cycle Wonk,

Long time no hear!!!

Good to hear from you - whats a matter too busy to post an E-wave read every 5 waves or so??

Miss studying your excellent reads.

What I really miss is some good glue - My bong has been retired way too long.gg

Haven't herd from stinky in a halflife - poor guy must have died from the cold - trading naked so long.

Didn't know your lurked here.

Good to see you are kicking!!

Bob



To: Bull RidaH who wrote (5426)11/14/2002 7:21:33 AM
From: GROUND ZERO™  Read Replies (1) | Respond to of 206881
 
Hey, great to see you here!!! You picture is very close, but I would not use the low made prior to the top, spin the spiral with the center at that July high, but ignore the low made earlier (the earlier low is part of a different spiral pattern already completed), use only the low made after the top, this is the low made this October... then you'll see the support at this level and the vertical will occur further out and higher up... I never use highs and lows made prior to any top or bottom where the center is being placed... but, yes, you have the idea... BTW, when the spiral goes vertical, that's where the market typically tops out or bottoms out, depending on which way you use the spiral... I think it's a great timing device... when used along with da cheif's CLX calculations, it's a winning combination... you may recall I mentioned the spiral at breakfast when you, Rich1, and I met several months ago...

GZ



To: Bull RidaH who wrote (5426)11/14/2002 8:41:52 AM
From: HairBall  Read Replies (2) | Respond to of 206881
 
Bull Ridah: How did you construct the spiral? TIA

Regards,
LG