Silicon Investor (SI) -- The First Internet Community

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Pastimes : Plastics to Oil - Pyrolysis and Secret Catalysts and Alterna -- Ignore unavailable to you. Want to Upgrade?

To: SteveF who wrote (5630)	3/15/2011 7:24:26 PM
From: SteveF	Respond to of 53574

Tank Install Date: 02/10/2011 Tank Install Date: 02/15/2011 Tank Install Date: 02/15/2011 Dec 15, 2010: Item 5.2: Compliance Demonstration shall include the following monitoring: ... 3. Within 30 days following issuance of this permit, JBI must submit to the Department an operation and malfunction plan to address proper capture and storage or control of the production gases. The operation and malfunction plan shall include procedures, methods, monitoring, recordkeeping and equipment used to ensure a bypass event does not occur. <snip> Item 10.2: Compliance Demonstration shall include the following monitoring: Monitoring Type: MONITORING OF PROCESS OR CONTROL DEVICE PARAMETERS AS SURROGATE Monitoring Description: The Water Seal Tank is equipped with a Caustic Addition System and Caustic Spray Column as a back-up to control and neutralize any potential low pH situation. A low pH situation is not expected and would only occur if any halogenated material is feed to the reactor by mistake. Should this occur then the off gas would become acidic and the pH of the water seal tank would drop. If the pH of the Water Seal Tank drops below 6.0, then the following corrective action is required: #1 – The feed system to the Reactor will automatically shut off. #2 – The caustic pump will start and caustic will be pumped to the top of the Spray Tower and through the Spray Nozzles to neutralize the material in the Water Seal Tank to control it at a pH of 7 to 8.