SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Politics : View from the Center and Left -- Ignore unavailable to you. Want to Upgrade?


To: koan who wrote (466520)1/28/2021 3:46:07 PM
From: Slumdog1 Recommendation

Recommended By
Doo

  Read Replies (1) | Respond to of 540795
 
The "cutter" measured the first one and cut it and then was about to measure the larger piece again and I had to explain to him all he had to do was lay the cut piece on top of the larger remaining piece and cut along the edge!
Koan, just curious, I assume this was a standard sheet of plywood, 4'x8' ?

Were the cuts made on the width or the length?