Silicon Investor (SI) -- The First Internet Community

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Politics : Formerly About Advanced Micro Devices -- Ignore unavailable to you. Want to Upgrade?

To: Tenchusatsu who wrote (1538622)	5/14/2025 4:26:42 PM
From: Eric	1 Recommendation Recommended By Doren Respond to of 1577883

T I've rebuilt 100's of ICE engines from scratch and a bunch of Lycoming and Continental aircraft engines over the years. The oil does not totally drain back into the pan. Typical bearing clearance in a new engine (Crankshaft journal to bearing shell) is around 1 thousandth of an inch or less and that oil sticks to those surfaces for a long long time. Most engines could run for well over a minute without oil pressure.before damage would occur. E