Silicon Investor (SI) -- The First Internet Community

STOCKTALK

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor. We ask that you disable ad blocking while on Silicon Investor in the best interests of our community. If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.

Technology Stocks : Advanced Engine Technologies (AENG) -- Ignore unavailable to you. Want to Upgrade?

To: wonk who wrote (631)	6/10/1998 1:35:00 AM
From: Sir Auric Goldfinger	Respond to of 3383

Bravo, WW for a job well researched! All 3 notes to the thread are impeccable and unimpeachable.

To: wonk who wrote (631)	6/10/1998 2:00:00 AM
From: Phil(bullrider)	Respond to of 3383

WW, Thank you very much for the obvious effort you expended in your research to find the U.S. patent, and for your comments. I know the longs don't want anything more than more cheer leading, but those of us on "the fence" want the good and the bad. The people that read the posts on SI are a very minimal portion of the investment community. Even if this company takes a little longer to mature and ferment, because of SI, I figure we will all be better off for the communication and exchange of information. If it fails, it will not be because of us. As has been previously posted, time is the investors' friend. We will not have to wait an indeterminate amount of time to see how this one plays out, IMHO. Thanks again, Phil

To: wonk who wrote (631)	6/10/1998 6:01:00 AM
From: 246810	Respond to of 3383

Excellent piece of work ww. You knew in your own heart you were right, as did most of us. It is refreshing to know that david travis is capable of civility after reading some of his posts. (See below.) The patent description leaves some ambiguity without the sketch. What are the chances of getting that? The high unit loading wear problem has me stumped. Two piston plates of 1" thickness sliding back and forth on a 2" diameter shaft while transmitting 150 lb-ft of torque are going to burn up pretty quick. And to get to Las Vegas before sun up will take more torque. But I guess that is where GM will spend some big bucks. Yes, ww, some of the more vulgar posters are in JJ or perhaps permanently terminated. They are obvious by their absence. Any additional uses of the term BF or other abusive or harassing posts will result in the same I am sure. I counted six, only three are resolved, the other three know the penalties since they are all connected. 246810