SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Technology Stocks : CYRIX / NSM -- Ignore unavailable to you. Want to Upgrade?

To: Jim McMannis who wrote (28742)8/7/1998 1:47:00 PM
From: FJB  Read Replies (1) | Respond to of 33344
 
Did you ask them where it was made?

Bob



To: Jim McMannis who wrote (28742)8/7/1998 5:50:00 PM
From: Paul Engel  Read Replies (1) | Respond to of 33344
 
McMannis - Re: "Called Cyrix and the 333 is a 2.9 volt chip..."

Plug it into your Mtech any way - it should run at 200 Mhz or so.

Paul



To: Jim McMannis who wrote (28742)8/7/1998 7:29:00 PM
From: Craig Freeman  Read Replies (3) | Respond to of 33344
 
Jim, my Mustang board 2.8v setting measured at almost 2.9 volts. It should work but why bother? Without a 100MHz bus and a better coprocessor, the actual performance improvement over the PR300 will be minimal. IMHO, instead of paying twice as much for the 333, you'd be better off upgrading something else (e.g. memory).

Craig


HomeMailHotSubjectMarksPeopleMarksKeepersSettings
Terms Of UseContact UsCopyright/IP PolicyPrivacy PolicyAbout UsFAQAdvertise on SI
© 2025 Knight Sac Media.  Data provided by Twelve Data, Alpha Vantage, and CityFALCON News