SI
SI
discoversearch

We've detected that you're using an ad content blocking browser plug-in or feature. Ads provide a critical source of revenue to the continued operation of Silicon Investor.  We ask that you disable ad blocking while on Silicon Investor in the best interests of our community.  If you are not using an ad blocker but are still receiving this message, make sure your browser's tracking protection is set to the 'standard' level.
Strategies & Market Trends : Systems, Strategies and Resources for Trading Futures
 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext  
To: SE who wrote (33724)9/15/1999 9:25:00 AM
From: Nemer  Read Replies (3) of 44573
 
Scoot ---

You're sick and NOT supposed to be wasting time looking at two wave nets .....

if you wish to pursue something valuable ...
try this ...

>>>>>>>>
Directions for Overclocking a BH6

Abit BH6/BX6 Rev.2:
1. Reboot Your System, on boot up push DELETE key to go to BIOS.
2. In BIOS Choose "CPU Soft Menu II"
3. Set "CPU Operating Speed" to "User Defined"

//// A. 450MHz Kits:
1. Set "Turbo Frequency" to "Disabled"
2. Set "Ext. Clock(PCI)" to "100MHz(1/3)"
3. Set "Multiplier Factor" to "x4.5"
4. Set "AGP Clock Speed" to "2/3"
5. Set "Speed Error Hold" to "Disabled"
6. Set "CPU Power Supply" to "User Defined"
7. Set "Core Voltage" to "2.3v"
8. Save and Exit, you should reboot at 450MHz

//// B. 464MHz Kits:
1. Set "Turbo Frequency" to "Enabled"
2. Set "Ext. Clock(PCI)" to "100MHz(1/3)"
3. Set "Multiplier Factor" to "x4.5"
4. Set "AGP Clock Speed" to "2/3"
5. Set "Speed Error Hold" to "Disabled"
6. Set "CPU Power Supply" to "User Defined"
7. Set "Core Voltage" to "2.3v"
8. Save and Exit, when you reboot it will show you at 450MHz but with the "Turbo Frequency" enabled you are actually running at 464MHz.

//// C. 504MHz Kits:
1. Set "Turbo Frequency" to "Disabled"
2. Set "Ext. Clock(PCI)" to 112MHz(1/3)"
3. Set "Multiplier Factor" to "x4.5"
4. Set "AGP Clock Speed" to "2/3"
5. Set "Speed Error Hold" to "Disabled"
6. Set "CPU Power Supply" to "User Defined"
7. Set "Core Voltage" to "2.3v" or "2.4v" **Use 2.3v First**
8. Save and Exit, you should reboot at 504MHz

Report TOU ViolationShare This Post
 Public ReplyPrvt ReplyMark as Last ReadFilePrevious 10Next 10PreviousNext  

HomeMailHotSubjectMarksPeopleMarksKeepersSettings
Terms Of UseContact UsCopyright/IP PolicyPrivacy PolicyAbout UsFAQAdvertise on SI
© 2026 Knight Sac Media.  Data provided by Twelve Data, Alpha Vantage, and CityFALCON News